If your Wii is newer than this, the HackMii Installer will Canīoot even if the rest of the system is completely corrupted.Īllows for safe backup / restore of NAND flash from SD card.Īllows direct boot of The Homebrew Channel, or otherĬons: Relies on a vulnerability in boot1 that was fixed mid-2008 Pros: Independant of system menu and the rest of NAND flash.

Is not found on the SD card, the drive slot LED will flashīriefly and the normal system menu will boot. * BootMii/boot2: This mode will install BootMii into 2 blank blocks in theīoot2 area of your Wii. Letters in Cyan are taken directly from the README-BootMii.txt.

Here you just wanna press continue.Ħ)You will be at the Main Menu(you can tell by the yellow letters at the top), go to 'BootMii.'ħ)There are a lot of options here so listen(or read) carefully: After some time, on the bottom, it'll state: 'Press 1 to continue'ĥ)You will be taken to some text saying ' The test results are in:' and 'The Homebrew Channel: Can be installed', 'BootMii: Can be installed'. It will stay on this screen for a good 20 seconds, just be patient. <-įor right now, I'm going to guess you are already hacked and have HBC installed(I'll go over unmodded Wii's near the end)ġ)Go to and Download HackMii Installer v1.2.Ģ)Place the HackMii folder in your apps folder you use for HBCģ)Go to HBC and there should be an app without a logo, just blank, but when you go to open it, it should be titled HackMii.Ĥ)As soon as you open it, an image should pop up stating 'THIS SOFTWARE MUST NOT BE SOLD' blah blah blah, some more scammed mumbo jumbo. > Try BootMii if Priiloader is not working for you. Now you no longer need a Wiimote to start booting up your ISO files, as a GC controller (d-pad) can navigate the Homebrew Channel.Īpparently you can have it boot straight to a Homebrew app if you want, but I've never done this. Then turn on Wii normally and it should now boot straight to the Homebrew Channel. hold those buttons until a white Priioader menu appears.ĩ) Go to the 'Settings' menu at the bottom.ġ0) At the top, change 'Autoboot' to 'Homebrew Channel'ġ2) Hold Power Button to turn off Wii.

Press A on GC controller (or whatever it says for Wiimote) to start the install.ħ) When it is done, exit back to the Homebrew Channel and then hold the power button on your Wii to turn it off.Ĩ) Turn Wii back on by holding the Power Button & the Reset Button, right below the power button, at the same time. 1) Have your Wii hacked so that the Homebrew Channel is available.Ĥ) From the downloaded and unzipped files, Copy the 'priiloader' folder, which is inside the 'apps' folder, and paste it into the 'apps' folder that should be on the root of your SD card.ĥ)Insert SD Card into Wii -> Boot up Wii -> go to Homebrew Channel -> load Priiloader.Ħ) Wait a second as it sets up some files.

Bootmii as boot2 or ios